Create Pick List and Thermal Label Printer Set-up

Please follow the below steps to connect your Thermal Label printer into C&D in Selro for automated label printing. 

Please go to Printer Set-up and intall the QZ printer software in your computer that is connected to your Thermal printer.

Once the Printer client is install, please search the printer by clicking the search and select the correct Thermal printer for your C&D. You can select different printers for each carrier that you are using e.g. DPD etc

Screenshot 2023-09-11 at 06.46.20.png

Please go to Thermal Label Setup and and select 'Print Label and Order Summary'. This will create a 4x4 Pick list for each of your C&D labels. 

Screenshot 2023-09-11 at 06.46.28.png

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.

Articles in this section